COVID-19 vaccines are required for all students and employees. In-person labs are operating on AMSC/WATR Center Campus, with COVID-19 precautions in place. Online classes are operating as usual. If you have trouble with registration, please call the AMSC/WATR Center main desk at 425.640.1840.

Advanced Manufacturing Skills Center

Introduction to Radio Controlled Robotics

  • ONLINE COURSE
  • Webcam and microphone are needed
  • Entry Level - No Prerequisite

 

Course Overview

A beginner course in the remote operation of various machinery.


This is a beginner course on radio control and specifically the operation of devices through RF signaling. This course was created for those looking to get into the UAV courses and similar but feel hesitant due to the deeper technological topics.

In this course we'll focus on the basic RF (radio frequency) understanding and the control of simple mechanisms. Our build for this class is and ground vehicle (RC car) but we'll also be adding video transmission capabilities as well and likely changing out some mechanical components. Just like the UAV course this will give us two different radio systems (2.4GHz and 5.8GHz) to work with and ultimately allow us to see where we're navigating in goggles as we drive. The control transmitter and video transmission units are the same make and model used in the UAV courses so we'll have good crossover training and the control receiver is only slightly different yet allowing us to do more traditional tasks such as servo control. All of this will be done without any advanced flight control system or higher end software so there won't have to be any concern about learning any of these items in order to operate.

Topics

  • RF Technology
  • Power control
  • Microcontrollers
  • Motor Drivers
  • Signal properties and troubleshooting
  • Antenna theory
  • Remote video systems
  • Video latency
  • Small mechanical drive systems
  • Gearing and gear ratio principles
  • Soldering skills
  • Wiring layout and signal concerns
  • Dealing with sensitive electronics in harsh environments
  • Conformal coating, device potting and other protection methods
  • Electronic troubleshooting and repair

Online Course Information

A few days prior to the course you will receive an email invite to the video class meetings. Typically this is Webex. We'd also recommend using the webex client install rather than the just the webpage video. Other items such as the class website and materials pick will also be discussed after class start. No materials are required for the first class sessions. All you need to do is log into the video meeting.


Class Dates and Times

Mailing List Signup - Click here to get notified of upcoming classes!

 

Introduction to Radio Control
Class Number 15116
March 16 - April 22, 2021
Tu, Th | 6:15 PM - 7:15 PM


 

Registration

New Students

First time taking a class at AMSC? Find out how to apply and register.

Get Started  Admissions Application

Returning Students

Note: When searching for AMSC classes, filter the Class Search by - Academic Organization: Manufacturing.

Class Search & Registration


Contact Damian Cianci at dcianci@edcc.edu if you have any questions.